Do you glue a shower drain?

After the subfloor of the shower is prepared and clean, install the bottom flange of the shower drain into the drainpipe, usually by solvent gluing.

Does a shower drain need AP Trap?

According to regulations, all shower drains are required to have P-traps. This includes all fixtures connected to a building’s main plumbing system. P-traps are curved pipes installed under showers and drains of all kinds.

How big is the hole for a oatey shower drain?

Cut a Hole In The Substrate Make sure that it’s 4.5 inches in diameter and that its center sits directly above the drainpipe beneath your shower floor.

How close should P-trap be to shower drain?

How far can P-trap be from shower drain? The maximum distance between the shower drain and the P-trap is 5 feet. However, the P-trap should be as close to the shower drain inlet as possible. You should even have the P-trap directly under the shower drain for the best results.

What drain to use for Curbless shower?

Channel drains, also called linear drains, in curbless showers are the ideal design solution for creating ADA-compliant showers and wet spaces that are universally accessible. With only one slope and no barrier to cross, the floor more easily accommodates a freestanding bench, a wheelchair, or some other mobility aid.

How big of a hole should I cut for a shower drain?

Install Drain Body in Shower Base before the Base is put in place on the floor. The Drain body is inserted from the top side and pressed firmly into place so that the Silicone Adhesive forms an even seal. 2″ Drain Pipe should be centered in a hole (approximately 5″ diameter) in the flooring.

What size hole do I drill for a shower drain?

Shower Drain Hole Size Most drains use 2-inch pipe, which means the subfloor will need a hole slightly larger than 2 inches for the drain to pass through once it is installed. Depending on the design of the drain body, the hole may need to be larger to incorporate other pieces.

How do I remove a shower drain without caulking?

How to Remove the No-Caulk Shower Drain Cover:

1. Use a screwdriver for the removal.
2. Place the end of the screwdriver under the notched area of the strainer.
3. Apply light upward pressure while being careful to not damage the finished surface.
4. No-caulk shower drain cover should release from shower base.

https://www.youtube.com/watch?v=f7Gb2SFjmnc